Fakir KT 83 Instruction Manual - Overview
GB
OVERVIEW
15
WARNING!
Never use a defective appliance.
NOTICE!
Keep the packaging for storage and future transports
(e.g. for moves, service).
• Please read the instructions carefully before use.
• Completely unroll the cable.
• Throw away the first lot of water after boiling.
• Remove all packing material and stickers.
• Place the heating base on a firm and level surface.
• Pour the desired amount of clean water into the kettle, Do
not touch any part of the kettle except the handle when
the appliance is in use, and ensure that the lid is properly
closed.
• The amount of water can be measured by the level mark
on the outside of the kettle, Always pay attention to the
minimum and maximum levels and ensure that the lid is
properly and firmly closed.
• Position the kettle in such a way on the base that the
underside of the kettle fits precisely into the contact on the
base.
• Insert the plug into a wall socket.
• Put the on/off switch to its ‘ON’ position to start the heating
process , The indicator lamp will light up .
• As soon as the water reaches boiling point, the on/off
switch return automatically to the OFF position, the
indicator lamp will go out. The water kettle can also be
switched off manually by putting the on/off switch to the
OFF position.
• The hot water may now be poured safely through the spout
into another container, safety cut – out.
• This kettle is equipped with a safety cut –out to protect the
appliance from damage in case of inappropriate use,
should the appliance be accidentally operated without
water or if all the water has evaporated the safety cut out
will automatically switch off the heating element
• In such a case remove the plug from the wall socket imme
diately and refill the kettle only after an adequate cooling
down period, about 15-20seconds.