Fakir MULTI FUN Instruction Manual - Operating
OPERATING
19
GB
Preparing the appliance
for operation and
switching on the
appliance
Take out a sufficient length of the supply cord and the
appropriate accessories from the compartment.
• Place the motor near the socket, on a hard, stable
surface. Do not cover the ventilation openings of the
housing.
• Open the compartment on the back of the housing and
take out an appropriate screen. (Figure 3)
A screen with 4mm openings is installed in the mincer
body as a standard.
• Wash all accessories thoroughly before the initial use.
Assemble the appropriate accessories and install them
on the motor.
• Plug in the appliance.
• Switch on the appliance using the „ I " switch (the
appliance starts to operate after about 2 seconds).
Mincing unit
Fit the following elements in the mincer body (Figure 4):
The scroll with the clutch facing to the inside of the body.
The cutter to the bolt with the blades facing the screen.
The screen so that the protrusion of the body fits the
groove in the circumference of the screen.
• Tightly fit all the elements of the mincer body.
• Place the assembled mincer body on the motor and turn
left until you hear a click. It means that the body has
been properly installed.
• Fit the tray to the mincer body.
Sausage filler nozzle
Place the following elements in the mincer body (Figure 5):
• The scroll with the clutch facing to the inside of the body.
• The base plate to the bolt.
The sausage filler nozzle.
• Tightly fit all the elements with the ring nut.
Soak the casing for about 10 minutes before fitting.
• Fit the wet casing on the sausage filler nozzle.
Make sure the not to block the ventilation openings on the
nozzle.
The meat cannot be „too thin". A large liquid content may
cause its leakage to the inside of the mincer.