Fakro ZWK10 User Manual - page 9
9
ZWK 10
1
2
!
3X
IN/EX
1X
IN/EX
PRIMARY
SECONDARY
SECONDARY
PRIMARY
Function is used for copying information about
devices from basic controller (PRIMARY) to additional
and making it a SECONDARY controller. After
performing LEARN MODE on the controller, it is also
necessary to assign device to buttons of movement
with the use of ASSOCIATE function. It is better to
perform LEARN MODE function after adding all
devices to basic controller or after modification of the
network.
Press once IN/EX button on basic remote
control. LEDs 1 and 4 will light up.
Within 1 0 sec. press three times IN/EX button on
additional remote control until lighting of LEDs 1
and 3.
Within 1 0 sec. on basic remote control LEDs 2
and 3 will light up and on additional 2 and 4 will
light up.
If the sequence does not occur, perform the
procedure from the beginning.
Note! With the use of an additional controller –
SECONDARY it is not possible to add device to
the network (INCLUDE) and remove device from
the network (EXCLUDE). However, it is possible
to perform ASSOCIATE and DELETE functions.
PRIMARY and SECONDARY function of the
controller can be performed by controllers from
different companies complying with Z-Wave
protocol.
To set the SECONDARY controller as
PRIMARY again, perform the DEFAULT
function.
Controller programming – basic functions
Adding another controller to the Z-Wave network – LEARN MODE