Falcon 1092 User's Manual & Installation And Servicing Instructions - page 26
26
Conversion to LP Gas
Servicing - warning
This conversion must be performed by a competent
person. After conversion the installation must comply
with the relevant regulations and also the local electricity
supply company requirements. Read the instructions
before converting this appliance.
Failure to convert the appliance correctly could invalidate
any warranty or liability claims and lead to prosecution.
This instruction must be used in conjunction with the rest
of the appliance instruction, in particular for information
on Standards, cooker positioning, connection hose
suitability etc.
When servicing or replacing gas-carrying components
disconnect from gas before commencing operation and
check appliance is gas sound after completion.
Do not use re-conditioned or unauthorised gas controls.
Conversion
Disconnect from electricity and gas before servicing.
Check appliance is safe when you have finished.
This appliance is CAT II 2H3+. It is supplied set for G20
natural gas at 20millibar
A conversion kit for LP gas is supplied with the cooker.
Injectors
Remove pan supports and burner heads.
Burner head
Brass venturi
Burner base
Burner ring
Undo the large brass nuts and remove the brass venturis
and brass rings.
Either:-
Use a long box spanner to access and remove the
old jets.
Or: -
Lift up the front of the hotplate top and prop it up.
The burner bases are now accessible - remove the
old jets.
Save the jets removed from the appliance for possible
future use. Fit the new jets; see the table for the correct
type.
Grill
Open the grill compartment door. Turn on the grill control
and check that the grill heats up.
Oven check
Turn on the ovens and check that they start to heat up.
Turn off the ovens.
Fitting the plinth
Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw.
Twist and fit each end keyhole over their respective
screws. Tighten the fixing screws.
Refit the drawer
Pull the side rails fully out.
Carefully move the drawer back between the rails and rest
it on the side rails.
At each side hold the front of the drawer and pull the side
rail forward so that the clips click into position holding the
drawer to the side rails.
Leave the levelling tool in the storage drawer, so that the
customer can use it if they wish to move the cooker.
Customer care
Please inform the user how to operate the cooker and
hand over these instructions.
Thank you.