Falcon Dominator Plus G3150 Installation And Servicing Instructions

Other manuals for Dominator Plus G3150: User Instructions
Manual is about: Fusion Range/Boiling Top

Summary of Dominator Plus G3150

  • Page 1

    Dominator plus g3151 fusion range g3150 fusion boiling top installation and servicing instructions this appliance must be installed and serviced by a competent person as stipulated by the gas safety (installation & use) regulations. Important the installer must ensure that the installation of the ap...

  • Page 2: Important Information

    Important information warranty policy shortlist warranty does not cover :- • correcting faults caused by incorrect installation of a product. • where an engineer cannot gain access to a site or a product. • repeat commission visits. • replacement of any parts where damage has been caused by misuse. ...

  • Page 3

    Model kw btu/hr open top 5.3 20,000 fusion burner (nat gas) 7.5 28.100 fusion burner (propane) 5.5 20,600 900mm oven 7.1 26,700 section 1 - installation unless otherwise stated, parts which have been protected by the manufacturer are not to be adjusted by the installer. 1.1 model numbers, nett weigh...

  • Page 4

    1.8 injector diameters model natural propane open top Ø1.93mm Ø1.2mm fusion burner Ø1.0 mm Ø 0.5mm ovens Ø2.2mm Ø 1.33mm 1.8.1 fusion burner pilot injectors natural gas propane gas g27.2 g22.1 1.9 gas pressure adjustment natural and propane gas the following supply pressures apply to both all units....

  • Page 5

    Section 2 - assembly and commissioning fixings 2.1 assembly note the following paragraphs should be read as applicable to the unit being assembled. A) unpack appliance and place it in position using feet adjusters to level appliance. B) units with castors should be fitted with accessories supplied a...

  • Page 6

    2.2 connection to gas supply connect appliance to gas supply and ensure that the governor supplied is fitted on natural gas installations. Test for gas tightness. The integral gas supply downstream of gas valve may be checked by applying leak detection spray with burner lit. Appliance inlet connecti...

  • Page 7

    Section 3 - servicing and conversion important before attempting any servicing, ensure isolating cock is turned off and cannot be inadvertently turned on. After any maintenance task, check appliance to ensure that it performs correctly and carry out any necessary adjustments as detailed in section 1...

  • Page 8

    3.1.5 solid top burner - to replace injector (figure 9) a) remove solid top castings. B) release pilot assembly from burner. C) remove burner. D) unscrew and remove existing injector. E) insert and screw in replacement injector. F) refit burner and ensure burner aeration adjustment. (see section 1.1...

  • Page 9

    Solid top low flame adjustment screw solid top burner test point 3.5.2 injectors injectors are best cleaned with a wooden splinter or soft fuse wire. Metal reamers may distort or increase orifice size and their use should be avoided. 3.6 thermocouples and flame failure device (ffd) 3.6.1 open top fl...

  • Page 10

    3.8 oven thermostat remove control knobs and fascia panel as detailed in section 3.2.1. Remove hob fitments as detailed in sections 3.2.2 and 3.2.3 as appropriate. Undo thermocouple connection at thermostat rear. Disconnect oven burner pipe. From inside oven, release clips that secures thermostat ca...