Falcon G2102 Installation And Servicing Instructions - page 11
Remove hob pan supports and burner head complete with aluminium bezel and venturi. The latter fits loosely upon
burner retaining ring.
The hob is retained by four ball-stud fixings. Pull hob upward to access burner supports.
Replace parts in reverse order.
Ensure burner head locates correctly upon burner bezel. This is achieved when the pips and notches of the parts
align to prevent burner head from rotating. Refer to Section 4 of User Instructions.
3.2.4 Removal of Oven Linings
Remove screws in bottom of oven back panel. Ease panel bottom edge forward slightly and pull down to release top
location thus enabling panel to be withdrawn from oven.
Ease rear edge of RH panel slightly toward centre then pull it back to release front location. Repeat for LH Panel. The
base panel can now be lifted out.
3.2.5 Removal of RH Outer Side Panel
Undo control panel fixings and slide panel forward.
Undo burner chamber grille fixings and remove.
Undo side panel fixings along front edge.
Undo side panel fixings along rear edge.
Remove panel.
3.3 GAS CONTROLS
To service gas controls, proceed as follows:
3.3.1 To Remove Oven Multifunctional Control
Remove RH outer side panel (refer to Section 3.2.5). The unit may have to be temporarily pulled forward to gain
access.
Undo thermocouple securing nut and pilot supply pipe at rear of control.
Remove plastic terminal box cover from valve and disconnect wiring.
Undo nuts on compression fittings on both inlet and outlet gas pipes.
Remove fixings securing fixing bracket to oven wall.
Remove fixing securing control bracket to valve.
Replace in reverse order.
When fitting a replacement control valve, transfer gas fittings and fixing bracket from old control to new.
Set adjustment of replacement valve as detailed in Sections 2.5.4, 2.5.5 and 2.5.6.
3.3.2 To Remove Open Top Gas Taps (G2102 only)
Remove hob control panel and hob. Refer to Sections 3.2.2 and 3.2.3.
Remove thermocouple connection from FFD section of tap.
Undo brass nut of compression fitting on gas supply pipe at gas tap rear.
Undo mounting screws and gently remove tap from supply manifold.
Replace in reverse order.
3.3.3 Regreasing Open Top Gas Taps (G2102 only)
Note - Plugs and bodies are machined in pairs and are therefore NOT INTERCHANGEABLE.
Always clean one tap at a time.
Remove hob control panel, refer to Section 3.2.2.
Remove fixings from tap body front. Withdraw spindle and niting arrangement to allow plug to be eased out.
Clean gas tap plug with a soft rag and regrease using an approved high temperature lubricant. Take care not to over-
grease as surplus may cause blockage in the gasways.
Replace parts in correct order and check for gas soundness.
3.4 THERMOCOUPLES
3.4.1 Oven Thermocouple
To replace, undo oven control panel fixings and slide out as detailed in Section 3.2.1. Remove burner chamber grille
and RH side panel (see Section 3.2.5) Undo nuts securing thermocouple at control valve and at pilot. Withdraw
through hole in oven wall. When replacing a thermocouple, do not bend to less than 15mm radius, and ensure that
connections are soundly made taking care not to overtighten valve nut. (Finger tight + quarter turn).