1. DL manuals
  2. Falcon
  3. Door locks
  4. PHASER2
  5. Manual

Falcon PHASER2 Manual

Summary of PHASER2

  • Page 1

    F a l c o n world class security falcon phaser2 advanced keyless entry system nationwide installation service 0800 622 474 helpline: 0906 700 10 20 (all calls charged at 50p/min) internet: http://www.Falcon-security.Com email: support@falcon-security.Com.

  • Page 2

    1. Features remote lock and unlock car finder total closure remote boot release code learning (up to 4 remotes) flashes hazard lights universal central locking siren/horn output 2. Button function table button door lock door unlock ignition on button #1 once lock lock lock button #1 2 sec. Car finde...

  • Page 3

    - lights flash once then stay on again to confirm the 1 st remote is programmed to the system - follow the same procedure as above to program the 2 nd , 3 rd and 4 th remote. You have up to 10 sec. For the learning of each remote the system will quit the learning mode as follows and the indicator li...

  • Page 4

    4.02 door unlock - press the unlock button once - doors unlock - lights flash twice - the siren/horn chirps twice (if connected) 4.03 boot release - press the boot release button (#) for 2 sec. Will operate the boot release output. 4.04 car finder - press the lock button for 2 sec. The horn/siren wi...

  • Page 5

    4.06 wiring diagram - c1-1 and c1-3 white -> lights flash outputs[+] connect c1-1 and c1-3 to indicator lights. - c1-2 white/red -> polarity input for c1-1 & c1-3[+ or -] connect c1-2 to positive or negative depending on the polarity of the cars indicator wires..

  • Page 6

    - c1-6 brown -> siren/horn output [1a] connect the red (+) wire of an optional siren for confirmation chirps. An additional relay will be required when connecting this output to the car horn instead of a siren; see the wiring below: - c1-7 yellow connect to an ignition wire that shows +12v when the ...

  • Page 7

    4.07 lock & unlock wiring.