Falcon Professional + F User Manual - page 35
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
33
Lift out the inner panel and place it, outer side up, on a clean
level surface. Undo the screws securing the hinge in place.
Remove the hinge. Replace the hinge and rebuild the door in
the reverse order.
17. To Remove the Oven Door Seal
Open the oven door. The seal is held in place by small hooks to
the cooker front. At the corner, pull the seal diagonally away
from the door centre until that hook is released
(Fig.9-8).
Proceed to the next hook and release it in a similar way, and
so on. Use force if the hooks are stiff, as the old seal will be
discarded.
When fitting the new seal, position the seal join at the bottom.
Hook the new seal in one of the corner holes of the door, and
proceed round the door snapping in each hook in turn.
18. To Remove the Oven Inner Backs
Disconnect the cooker from the electricity supply.
Open the oven door. For the right-hand side unscrew the 4
thermostat phial fixing screws.
Remove the fixings that secure the inner back to the oven rear
(Fig.9-9). Lift the removable panels away.
Re-assemble in reverse order. Ensure that the retaining fixings
are fully tightened.
19. To Replace an Oven Fan
Disconnect the cooker from the electricity supply.
Pull the cooker forward to access the cover boxes at the rear of
the cooker.
Remove the inner back (see 18).
Hold the fan blades and undo the centre nut (LH thread), brass
washers, fan blade and circlip (Fig.9-10). Undo the screws that
retain the fan and remove it from the cavity rear.
Fit the replacement and re-assemble parts in reverse order.
Check that the oven operates satisfactorily.
20. To Remove an Oven Fan Element
Disconnect the cooker from the electricity supply.
Remove the inner back (see 18).
Remove the screws that secure the element within the oven
and carefully lift the element away (Fig.9-11).
Disconnect the leads and connect to the replacement element
and re-assemble parts in reverse order.
ArtNo.281-0148
- USA Oven Fan
ArtNo 281-0149
- USA oven fan element
Fig.9-10
Fig.9-11
ArtNo.320-0005 Oven door rubber seal
Fig.9-8
ArtNo.281-0149 - Fan oven inner
Fig.9-9