Famastil F-Power Instruction Manual - page 32
32
ENGL
IS
H
WARNING! Use only the recommended diamond wheel with the correct hole size.
CUTTING DEPTH ADJUSTMENT (PIC 2)
To increase or decrease the depth of
cut, loosen the depth-of-cut adjustment
lever.
For minimum depth of cut, move/
slide the wing nut towards the number
zero (0mm).
To increase the depth of cut, move/
slide the wing nut towards the number
thirty (30mm).
At the desired depth of cut, secure the
base by tightening the adjustment lever.
CUTTING ANGLE ADJUSTMENT (PIC 3)
To adjust the cutting angle of the saw,
loosen the wing nut and move/slide the
base as shown in Picture 3.
01
01
02
02
03
03
04
At anytime, the depth-of-cut adjustment
knob can also be set to a desired position
to suit the user.
PIC 2
To set the desired angle, align the top of
the marker with the desired angle (PIC 3).
Tighten the wing nut to fix the angle
and start cutting.
30º
FIG 3
MARBLE CUTTER ADJUSTED FOR A 30° CUT
INSTRUCTION FOR USE
WARNING! Always observe the safety instructons and applicable regulations.
WARNING! Ensure that the depth-of-cut adjustment lever
is properly tightened before operating the tool.