Famastil F-Power Instruction Manual - page 33
33
ENGL
IS
H
SWITCHING ON AND OFF (PIC 4)
To switch the tool on, press the on/off
switch.
To switch the tool off, release the
on/off switch. This tool has a lock-on
feature.
To activate press the on/off switch
and the then lock-on button.
To de-activate press the on/off button
again.Always switch off the tool when
work is finished and before unplugging.
MOTOR BRUSHES (PIC 5)
Remove and check carbon brushes
regularly. Replace when they have worn
down to about 6mm or less.
Keep carbon brushes clean for free move-
ment in the holder. Both carbon brushes
should be replaced at the same time.
Use only Famastil F-POWER carbon
brushes.
Take out worn brushes, insert new
ones, and secure the brush caps.
01
01
02
03
04
02
03
04
PIC 5
PIC 4
Botón de
encendido/apagado
Botón de bloqueo
CUTTING (PIC 6)
Align the edge of the front of the base
with the cutting line on the work piece.
Hold the tool firmly.
Set the base on the work piece to be cut
without the wheel making any contact.
Turn tool on and wait until the wheel
attains full speed.
Move the tool forward over the work
piece surface, advancing smoothly until
the cut is completed.
Keep the cutting line straight. This
tool should only be used on horizontal
surfaces. Be sure to move the tool gently
01
02
03
04
05
forward, in a straight line. Forcing, or
exerting excessive pressure, or allowing
the wheel to bend, pinch or twist in the
cut can cause the motor to over heat and
tool to kickback dangerously.
PIC 6