Famastil Furadeira Instruction Manual - page 29

29

ENGL

IS

H

WARNING!

 Never change the direction of rotation with the chuck on movement.

SWITCHING ON AND OFF  (PIC 7)

  To switch the tool on, press the 

variable speed switch. The tool speed 

depends on how far you press the 

switch.

  To switch the tool off, release the 

variable speed switch.

PIC 7

SELECTING THE OPERATING MODE

OR TORQUE

This tool is fitted with a collar to select 

the operating mode and to set the 

torque for tightening screws. Large 

screws and hard workpiece materials 

require a higher torque setting than 

small screws and soft workpiece 

materials. The collar has a wide range

of settings to suit your application:

  For drilling in wood and plastics, 

set the torque selector to the drilling 

position by aligning the symbol   with 

the marking (PIC 5).

  For screwdriving, set the torque 

selector to the desired setting. If you do 

not yet know the appropriate setting, 

proceed as follows:

• Set the torque selector to the lowest 

torque setting. (PIC 6).

• Tighten the first screw. If the clutch 

ratchets before the desired result is

PIC 5

PIC 6

achieved, increase the torque selector 

setting and continue tightening the 

screw. Repeat until you reach the 

correct setting. Use this setting for the 

remaining screws.

LOWEST TORQUE SETTING

HIGHER TORQUE SETTING

01

01

02

02

BUILT-IN LEVEL   

The built-in level at the top of the screwdriver is to improve the precision on drilling 

or using a wood screw. This allows the user to control of the angle of the drill / 

screw so that the hole can be made more straight, improving the ability to withstand 

weight.