Famastil Serra Circular Instruction Manual - page 41
41
ENGL
IS
H
HINTS FOR OPTIMUM USE
As some splintering along the line of cut on the top side of the workpiece
cannot be avoided, cut on the side where splintering is acceptable.
Where splintering is to be minimized, e.g. when cutting laminates, clamp a
piece of plywood onto the top of the workpiece.
POCKET CUTTING
Pocket cutting is used to cut a hole in a
piece of material without cutting from
the side.
Measure and mark work.
Tilt saw forward and rest front of the
shoe on material to be cut. Align so
that cut will begin at the back of the
drawn rectangle shown in figure 14.
Using the retracting lever, retract
blade guard to an upward position, with
WRENCH STORAGE
The spanner wrench (8) can be stored
on the saw shoe as shown in figure 15.
PIC 14
PIC 15
WARNING!
As blade starts cutting the material, release the retracting lever immediately.
• Never tie the blade guard in a raised position.
• When the shoe rests flat on the material being cut, complete the cut in
forward direction.
• Allow the blade to come to a complete stop before lifting saw from material.
• When starting each new cut, repeat the above steps.
01
01
02
03
02
the blade just clearing the material,
start motor and gradually lower the saw
into the material.