Famastil Serra Circular Instruction Manual - page 42
42
ENGL
IS
H
IMPORTANT! To ensure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment (other than those listed in this manual)
should be performed by authorized service centers.
TOOL CARE
Avoid overloading the machine. Overloading will result in a considerable reduction in
speed and efficiency and the unit will become hot. In this event, run the machine at
no load for a minute or two until cooled to normal working temperature by the built in
fan. Switching your machine on and off whilst under load will considerably reduce the
life of the switch.
WARNING! NEVER spray or in any other way apply lubricants or cleaning
solvents inside the tool. This can seriously affect the life and performance
of the tool and may result in personal injury.
LUBRICATION
Famastil F-POWER tools are properly lubricated at the factory and are ready for use.
However, it is recommended that, once a year, you take or send the tool to a certified
service center for a thorough cleaning and inspection.
WARNING! Before performing any maintenance, switch off and unplug the tool.
ACCESSORIES
The performance of your tool depends on the accessory used. Famastil accessories
are engineered to high quality standards and designed to enhance the performance
of your tool. By using these accessories you will get the very best from your tool.
MAINTENANCE
Your tool has been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper tool care and
regular cleaning.
01
02
Regularly clean the ventilation slots in your tool using a soft brush or dry cloth.
Regularly
clean the motor housing using a damp cloth. Do not use any abrasive or
solvent-based cleaner.