Fametech PKB-059 Series User Manual - page 18
Master key German K/B
Key position mapping 3F Mode 1 key code mapping 6A
Remark:
* *
is change mode key
*
Input key position:
to disk
G. Input key position code as per the left table on Figure A and input
key code as per Figure B for each key you want to program. Or
press “F2” to set initial code to whole table of Mode 1 and make
some changes on some keys if the new code on Mode 1 only
changes a little from the initial one. Or press “F3” to set the past
mode code to the whole table of Mode 1 and make some changes
on some keys if the new code on Mode 1 only changes a little from
the past mode code. (This would not work if the past mode code
hadn’t been saved in the disk.)
Note: While in programming,
H. Press “F1” to return to main menu after programming all keys on
Mode 1. Or press “F4” to save this programmed Mode 1 code to
17