Family inada chair i.1 HCP-i1 A Operating Manual - page 11
19
20
Cleaning And Storage
Cleaning And Storage
Cleaning And Storage
●Store the chair in a dry area after cleaning
it.
●To keep it away from dust, please make
sure the cover is put on.
How to remove the footrest cover
Storage
How to remove covers
Caution
Do not keep the chair in a dusty
or high-temperature (104˚F/40˚C)
area.
Do not keep the chair near a stove
or in direct sunlight which may
cause discoloration or
degeneration of the external
parts.
Warning
When any cleaning is being carried
out, make sure that the plug is
disconnected from the socket. Do
not connect or disconnect the
power plug with wet hands. You
may be exposed to the danger of
electric shock and injury.
Before any cleaning is
carried out, make sure
that the power is turned
off and the plug is
disconnected from the
socket.
Cleaning
●Plastic parts, pipes, and fabric should be cleaned by wiping with a mild detergent and a damp cloth. Wipe
with a dry cloth to dry the chair surface.
Never use alcohol, solvents or abrasive agents. Using these chemicals may cause scratches, discoloration and/or cracks.
Main parts
●Remove stains by wiping with a mild detergent and a damp cloth. Wipe with a dry cloth to dry the chair
surface.
Caution
Caution
Long contact with vinyl or plastic material or wallpaper may cause discoloration.
Back pad
Headrest
Covers
①Remove the Velcro-fastened seat cover from the
sliding cover.
②Unzip the sliding cover from the footrest cover.
③Unzip the footrest cover from the main body of the
chair.
※To replace the footrest cover, repeat the above
procedure in the reverse order.
How to remove the seat cover
①Remove the Velcro-fastened seat cover from the
sliding cover.
②Remove the Velcro-fastened seat cover from the
main body of the chair (by undoing the six Velcro
pieces of tape)
※To replace the seat cover, repeat the above
procedure in the reverse order.
How to remove the backrest cover
①Undo the Velcro tapes that fasten the backrest cover to the
headrest. Remove the headrest.
②Unzip the back pad from the main body of the chair.
③Remove the backrest cover from the main body of the chair by
undoing the nine Velcro pieces of tape.
※To replace the backrest cover, repeat the above procedure in
the reverse order.
●Remove stains by using a dry cloth.
Caution
Never use a wet cloth. Moisture can damage the control.
Remote control
Pulling
the plug
Zipper
Velcro
Sliding cover
Zipper
Footrest cover
Seat
Seat cover
Back side of
seat cover
Main parts of
the seat
Sliding cover
Velcro
Velcro
Velcro for slide cover
Footrest
Velcro
Zipper
Backside of zipper
Headrest
Velcro
Backrest
Hardrest
Back pad
Backrest cover
Back pad