Fangscoo-alarm TK103 User Manual - page 7
Fangscoo-alarm Co.,Ltd
www.fangscoo-alarm.com
www.fangscoo.cn
7
5.3 Startup
5.3.1
Installed the tracker in the car,then put the SIM card into the tracker host outdoors.
5.3.2
For first use, please initialize the unit and restore it to default setting.( please refer to 5.4 for instruction.)
5.3.3
or 40 seconds, the unit will begin to work and acquire the GSM signals as well as the GPS signals, and
the red indicator will keep flashing every 2 seconds when the GPS module is in standby mode. When the blue
indicator is keep shine, the unit has been located.
5.3.4
When this unit receives GPS signals normally, you can use it and do all the following settings.
5.4 Initialization
Send “begin+password” in SMS to the unit, it will reply “begin ok” and initialize all the settings. (Default
password: 123456)
5.5 Change the password
5.5.1 Send SMS "password+old password+space+new" password to change the password.
Remark: Make sure the new password is in 6 digits, or else the tracker can not recognize the password.
5.5.2 you can Send "resume+password" to the tracker, to restore the original setting in case of losing the new
password.
5.6 Authorization
Emergency triggering alarm
The blue wire connects the anode of the
alarm button, and the black wire connects the
cathode of the alarm button.
Power supply line
The red wire connects 12V “ +”;Black wire
connects to12V
“-”