Fanimation Alamosa FP3820RP Owner's Manual - page 5
5
How to Assemble Your Ceiling Fan
Pin
Setscrew
Hanger
Ball
Figure 1
1. Remove the Hanger Ball by loosening the setscrew
in the Hanger Ball until the ball falls freely down the
Downrod. (Figure 1) Remove the Pin from the Downrod,
then remove the Hanger Ball. Retain the Pin and Hanger
Ball for reinstallation in Step 8.
2. The fan comes with blue, black, and white 80˝ wires
and safety cable. Separate and untwist the three wires and
safety cable. Route the wires through the Downrod.
NOTE: You will be using either the 6˝ downrod supplied with
your fan or an optional downrod purchased seperately.
3. Loosen the two setscrews in the Downrod Support. Align
the Clevis Pin holes in the Downrod with the holes in the
Downrod Support. Install the Clevis Pin and secure with
the Hairpin Clip. (Figure 3) Be sure to push the straight
leg of the hairpin clip through the hole near the end of the
clevis pin until the curved portion of the hairpin clip snaps
around the clevis pin. The hairpin clip must be properly
installed to prevent the clevis pin from working loose. Pull
on the Downrod to make sure the clevis pin is properly
installed.
NOTE: The setscrews must be properly installed as
described above, or fan-wobble could result.
4. Route wires and safety cable through opening in Canopy.
Position Canopy on fan shown with open side facing up.
(Figure 4)
5. Reinstall the Hanger Ball (Figure 2) on the Downrod
as follows. Route the three 80˝ wires and safety cable
through the Hanger Ball. Position the Pin through the two
holes in the Downrod and align the Hanger Ball so the Pin
is captured in the groove in the top of the Hanger Ball. Pull
the Hanger Ball up tight against the pin. Securely tighten
the setscrew in the Hanger Ball. A loose setscrew
could create fan wobble.
Clevis
Pin
Setscrew (2)
Figure 2
Ceiling
Canopy
Setscrew
Downrod
Pin
Figure 3
Hairpin Clip
Downrod
Support
▲WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the setscrews are securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.