Owner’s manual read and save these instructions model no. Fp4320** the belleria ® ceiling fan wet location model net weight 9.9 kg (21.78 lbs).
Table of contents unpacking instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 electrical and structural requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....
This manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will be...
4 electrical and structural requirements your new ceiling fan will require a grounded electrical supply line of 120 volts ac, 60 hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Figure 1 depicts different structural configurations th...
5 note: you will be using either the 6˝ downrod supplied with your fan or an optional downrod purchased seperately. 4. Loosen the two setscrews and hex nuts in the downrod support. Screw downrod into coupler. Align the clevis screw holes in the downrod with the holes in the downrod support. (figure ...
6 how to hang your ceiling fan figure 1 floor ceiling no less than 7 ft ▲warning to avoid possible electrical shock, be sure electricity is turned off at the main fuse box before hanging. Note: if you are not sure if the outlet box is grounded, contact a licensed electrician for advice, as it must b...
7 how to wire your ceiling fan - pull chain operating instructions - pull chain if you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. 1. Connect the green grounding lead from the hanger ball and the green grounding lead ...
Mounting the fan blades 2. Lay flat side of blade holder arm on a flat surface with the inside of the blade holder arm facing up. This is the side with the threaded posts and pitched foot. 3. Position the (plastic) palm leaf, or the (plastic) woven bamboo blade, or the (plastic) wood blade over the ...
9 maintenance blade cleaning periodic cleaning of your new ceiling fan is the only maintenance that is needed. When cleaning, use only a soft brush or lint free cloth to avoid scratching the fi nish. Abrasive cleaning agents are not required and should be avoided to prevent damage to fi nish. Period...
10 before discarding packaging materials, be certain all parts have been removed parts list model #fp4320** ¾¾ insert finish codes (refer to fan model number located on downrod support) how to order parts when ordering repair parts, always give the following information: • part number • part descrip...
11 note: the illustration shown is not to scale or its actual confi guration may vary the belleria ® fp4320** exploded-view 1 ground wire (green) figure 1 2a 2b 2c 2d 2 3 4 5 7 6 2f 8 2e.
12 trouble shooting trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connections in the switch housing. 3. Reversing switch in neutral position. 1. Check main and branch circuit fuses or c...
10983 bennett parkway zionsville, in 46077 (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 733-4113 visit our website @ www.Fanimation.Com copyright 2007 fanimation 2007/10
