Owner’s manual read and save these instructions model no. Fp4320**1 the belleria ® ceiling fan wet location model net weight 9.9 kg (21.78 lbs).
Table of contents unpacking instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 electrical and structural requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....
This manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will be...
4 electrical and structural requirements your new ceiling fan will require a grounded electrical supply line of 120 volts ac, 60 hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Figure 1 depicts different structural configurations th...
5 figure 5 figure 6 figure 2 figure 4 how to assemble your ceiling fan (cont’d) downrod black, blue and white lead ceiling canopy motor coupling cover canopy screw cover note: you will be using either the 6 ˝ downrod supplied with your fan or an optional downrod purchased separately. 2. The fan come...
6 how to hang your ceiling fan figure 10 figure 9 outlet box hanger bracket outlet box hanger bracket screw (2) supplied with outlet box machine screw (2) mounting outlet box tab downrod/hanger ball assembly figure 7 main fuse box figure 8 floor ceiling no less than 7 ft note: if you are not sure if...
7 how to wire your ceiling fan - pull chain if you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. 1. Connect the green grounding lead from the hanger ball and the green grounding lead from the hanger bracket to the suppl...
Mounting the fan blades 8 operating instructions-pull chain (cont’d) installation note do not connect fan blades until the fan is completely installed. Installing the fan with blades assembled may result in damage to the fan blades. Figure 17 figure 14 figure 15 1. Remove and discard the (rubber) mo...
9 maintenance blade cleaning periodic cleaning of your new ceiling fan is the only maintenance that is needed. When cleaning, use only a soft brush or lint free cloth to avoid scratching the fi nish. Abrasive cleaning agents are not required and should be avoided to prevent damage to fi nish. Periodic...
10 before discarding packaging materials, be certain all parts have been removed parts list model #fp4320**1 insert finish codes (refer to fan model number located on downrod support) how to order parts when ordering repair parts, always give the following information: • part number • part descripti...
11 note: the illustration shown is not to scale or its actual confi guration may vary the belleria ® fp4320**1 exploded-view 1 figure 1 2 3 4 5 6 8 7 9.
12 trouble shooting trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connections in the switch housing. 3. Reversing switch in neutral position. 1. Check main and branch circuit fuses or c...
10983 bennett parkway zionsville, in 46077 (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 733-4113 visit our website @ www.Fanimation.Com copyright 2010 fanimation 2010/09.
