Fanimation Belleria FP4320 Series Owner's Manual - Mounting The Fan Blades
Mounting the Fan Blades
8
Operating Instructions-Pull Chain (Cont’d)
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
Figure 17
Figure 14
Figure 15
1. Remove and discard the (rubber) motor “stops”
by removing the four screws. (Figure 17)
Installing the Canopy Housing
Figure 16a
Figure 16b
2. Securely attach and tighten the Canopy Screw
Cover over the shoulder screws in the Hanger Bracket
utilizing the keyslot twist-lock feature (Figure 16b).
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 16a)
NOTE: This step is applicable after the necessary wiring
is completed.
3. Check the operation of the fan by gently pulling
on the pull chain switch. (Figure 14) Your fan model is
equipped with a 4-position, 3-speed, pull chain switch.
The operating sequence is as follows:
1st Pull = HIGH
3rd Pull = LOW
2nd Pull = MEDIUM
4th Pull = OFF
4. If airflow is desired in the opposite direction,
turn the fan off and wait for the blades to stop
turning. Then slide the reverse switch to the
opposite position and turn fan on again.
(Figure 15)