Fanimation CANCUN FP8042 SERIES Owner's Manual - page 9
9
Housing/Switch Cup Adapter Assembly
1. Disassemble the housing switch cup/adapter assembly
by removing three screws. (Figure 19)
Figure 19
HOUSING/SWITCH
CUP ADAPTER
2. Remove one of the three screws in the support
bracket. Slightly loosen the remaining two screws.
Assemble the adapter assembly to the housing support
bracket using the two key slots in the adapter assembly.
Replace the third screw and securely tighten all three
screws. (Figure 20)
Figure 20
SCREWS (3)
ADAPTER
ASSEMBLY
3a. Securely attach the 9-pin switch cup connector to
the wiring harness socket within the adapter assembly.
(Figure 21a)
Figure 21a
ADAPTER
ASSEMBLY
3b.
>
Connect the 2-pin
connector from the switch cup housing light
fitter
to the
2-pin connector from the motor assembly.
(Figure 21b)
Figure 21b
4. Install the housing switch cup onto the assembled
adapter with the three screws removed in step 1.
(Figure 22)
Figure 22
FP8009OB
FP80011OB
FP8009OB
FP80011OB
HOUSING/SWITCH
CUP ADAPTER
WITH LIGHT FITTER