Fanimation FP4820PW The Cumulos Owner's Manual

Other manuals for FP4820PW The Cumulos: Owner's Manual

Summary of FP4820PW The Cumulos

  • Page 1

    Model no. Fp4820pw the cumulos ™ ceiling fan net weight 10.8 kg (23.8 lbs) owner’s manual read and save these instructions.

  • Page 2

    1. Limited lifetime motor warranty - if any part of your fan motor fails, due to a defect in materials or workmanship during the lifetime of the original purchaser, fanimation will provide the replacement part free of charge, when the defective fan is returned to our national service center. Proof o...

  • Page 3

    9. It is understood that any repair or replacement is the exclusive remedy available from fanimation. There is no other expressed or implied warranty. Fanimation hereby disclaims any and all implied warranties, including, but not limited to those of merchantability and fitness for a particular purpo...

  • Page 4

    This manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will be...

  • Page 5

    5 energy efficient use of ceiling fans ceiling fan performance and energy savings rely heavily on the proper installation and use of the ceiling fan. Here are a few tips to ensure efficient product performance. Choosing the appropriate mounting location ceiling fans should be installed, or mounted, ...

  • Page 6

    6 electrical and structural requirements (continued) if your fan is to replace an existing light fixture, turn electricity off at the main fuse box at this time and remove the existing light fixture. Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity i...

  • Page 7

    Figure 3 3. Fasten cable hanger to support arm with screw provided, 3 places. (figure 3) 7 how to assemble your ceiling fan 1. Assemble cable support arms on top of fan motor with screws (2 per arm) provided. (figure 1) 2. Route the top of cable hanger through each hole on underside of the acrylic d...

  • Page 8

    Canopy figure 6 9. While pulling up on the hanger ball, securely tighten the three setscrews in the downrod support. (figure 5) note: the setscrews must be properly installed as described above, or fan-wobble could result. 10. Slide the motor coupling cover down until it touches the top of the housi...

  • Page 9

    9 figure 1 floor no less than 7 ft the fan must be hung with at least 7´ of clearance from floor to blades (figure 1) ▲ warning ▲ warning ▲ warning to avoid possible electrical shock, be sure electricity is turned off at the main fuse box before hanging. Note: if you are not sure if the outlet box i...

  • Page 10

    Installing the canopy housing figure 1a figure 1b note: this step is applicable after the necessary wiring is completed. 1. Loosen the two shoulder screws in the hanger bracket with a screwdriver (figure 1a). 2. Securely attach the canopy housing over the shoulder screws (figure 1b). 3. Securely att...

  • Page 11

    How to operate your remote control 11 3v, cr2032 battery 2 pcs • hi push button – high fan speed • med push button – medium fan speed • low push button – low fan speed • off push button – fan off • light push button – toggles on/off and brightness control for optional light arms reverse switch infor...

  • Page 12

    12 figure 1 replacing light bulbs 1. Turn off power. 2. Remove burned-out bulb(s). By gently pressing upward on the bulb, twisting counter-clockwise and pulling out the bulb. (figure 1). 3. Firmly seat the new bulbs in their sockets. By aligning pins with slots in socket, gently pressing upward and ...

  • Page 13

    13 before discarding packaging materials, be certain all parts have been removed parts list model #fp4820pw 2 1 hanger bracket assembly with shoulder screws(2) adrqm1-6pw apgqm410r hanger ball assembly how to order parts contact your retail store for repair parts. When ordering repair parts, always ...

  • Page 14

    Note: the illustration shown is not to scale or its actual configuration or finish may vary. The cumulos ™ fp4820pw 4 1 figure 1 3 2 3a 6 9 10 11 8 5 14 7 exploded-view illustration.

  • Page 15

    10983 bennett parkway zionsville, in 46077 toll free (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 733-4113 visit our website www.Fanimation.Com copyright 2015 fanimation 2015/07 v.01.

  • Page 16: The Cumulos

    Modelo n.º fp4820pw the cumulos ™ ventilador de techo peso neto 10,8 kg (23.8 lb) manual del propietario lea y guarde estas instrucciones.

  • Page 17

    Instrucciones de seguridad importantes advertencia: siga estas instrucciones para prevenir incendios, descargas eléctricas y lesiones personales graves. 1. GarantÍa limitada de por vida del motor - si se produjera una falla en alguna de las partes del motor de su ventilador debido a un defecto en lo...

  • Page 18

    9. Se entiende que las reparaciones y las sustituciones son el único recurso disponible de fanimation. No existe ninguna otra garantía expresa o implícita. Por la presente, fanimation niega todas las garantías implícitas, que incluyen, entre otras, la comerciabilidad y la aptitud para determinado fi...

  • Page 19

    Este manual está diseñado para facilitar al máximo el ensamblaje, la instalación, el funcionamiento y el mantenimiento de su ventilador de techo. Instrucciones para el desempaque para su comodidad, marque cada uno de los pasos. A medida que completa cada paso, coloque una marca de veri fi cación. Con...

  • Page 20: Uso E

    Requisitos eléctricos y estructurales su nuevo ventilador de techo requiere una línea de suministro eléctrico con conexión a tierra de 120 voltios de ca, 60 hz, circuito de 15 amperios. La normativa eléctrica requiere el uso de una caja de distribución eléctrica para ventiladores que soporte el peso...

  • Page 21

    Advertencia no utilice este ventilador con un controlador variable de pared (rheostat) o un regulador de intensidad. Si lo hiciera podría dañar la unidad del mando a distancia del ventilador de techo. Requisitos eléctricos y estructurales (cont.) si su ventilador va a sustituir una instalación de il...

  • Page 22

    22 cómo ensamblar el ventilador de techo 1. Ensamble el soporte del cable (3) en la parte superior del motor del ventilador con los tornillos (2 por soporte) incluidos. (figura 1) 2. Pase la parte superior del soporte del cable a través de cada orificio en la parte inferior del disco de acrílico. (f...

  • Page 23

    23 cómo ensamblar el ventilador de techo (cont.) 4. Afloje el tornillo de fijación de la semiesfera para lograr que ésta pueda desplazarse libremente por el barral. (figura 4) retire el pasador del barral y luego extraiga la semiesfera. Conserve el pasador y la semiesfera para su reinstalación en el...

  • Page 24

    24 figura 1 piso 2 m (7 pies) como mínimo ▲ advertencia las aspas del ventilador deben estar suspendidas, al me- nos, a 2 m (7´) del piso (figura 1) ▲ advertencia la caja de distribución eléctrica debe estar bien asegurada a la estructura armada y ser capaz de soportar una carga de, al menos, 15,9 k...

  • Page 25

    25 cómo realizar la instalación eléctrica del ventilador de techo 1. Configuración del código: la unidad del control remoto cuenta con 16 combinaciones de código diferentes. Para evitar posibles interferencias desde o hacia otras unidades de control remoto como la de apertura de puertas del garaje, ...

  • Page 26

    Cómo utilizar su control remoto de mano 1. Importante: el uso de un regulador de la intensidad completa (no incluido) para controlar la velocidad del ventilador dañará el dispositivo. Para reducir el riesgo de incendio o descarga eléctrica, no utilice dicho regulador para controlar la velocidad del ...

  • Page 27

    Botón hi (alto) – velocidad del ventilador alta botón med (medio) – velocidad del ventilador media botón low (bajo) – velocidad del ventilador baja botón off (apagado) – ventilador apagado botón de iluminación – encendido/apagado, sostenga para lograr un nivel infinito de iluminación figura 3 3v, cr...

  • Page 28

    Solución de problemas ▲ advertencia para su propia seguridad, desconecte la electricidad de la caja de fusibles o disyuntor antes de solucionar problemas en su ventilador problema causa posible solución sugerida 1. El ventilador no arranca 1. El fusible o el disyuntor están fundidos. 2. Las conexion...

  • Page 29

    29 lista de piezas modelo n.° fp4820pw n.º de ref. Descripción pieza n.º 1 unidad del soporte de suspensión con tornillos de reborde (2) apgqm410r 2 adrqm1-6pw unidad de la semiesfera antes de desechar los materiales de embalaje, asegúrese de haber extraído todas las piezas 3 ceiling canopy pgqm1001...

  • Page 30

    4 1 3 2 3a 6 9 10 11 8 5 7 nota: la ilustración que se muestra no está hecha a escala y su configuración real o terminación puede variar. The cumulos ™ fp4820pw figura 1 30 ilustración del despiece.

  • Page 31

    10983 bennett parkway zionsville, in 46077 llame sin cargo al (888) 567-2055 fax (866) 482-5215 desde fuera de los ee.Uu., llame al (317) 733-4113 visite nuestro sitio web en www.Fanimation.Com copyright 2015 fanimation 2015/107 v.01.