Model no. Fp4820pw the cumulos ™ ceiling fan net weight 10.66 kg (23.5 lbs) owner’s manual read and save these instructions.
1. Limited lifetime motor warranty - if any part of your fan motor fails, due to a defect in materials or workmanship during the lifetime of the original purchaser, fanimation will provide the replacement part free of charge, when the defective fan is returned to our national service center. Proof o...
This manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will be...
4 electrical and structural requirements your new ceiling fan will require a grounded electrical supply line of 120 volts ac, 60 hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Figure 1 depicts different structural configurations th...
5 how to assemble your ceiling fan (cont’d) figure 4 figure 3 pin setscrew hanger ball 4. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod. (figure 4) remove the pin from the downrod, then remove the hanger ball. Retain the pin and hang...
6 figure 1 floor no less than 7 ft ▲warning the fan must be hung with at least 7´ of clearance from floor to blades (figure 1) ▲warning the outlet box must be securely anchored to building structure and capable of withstanding a load of at least 50 lbs. Hanger bracket must seat fi rmly against outle...
7 ▲warning failure to seat tab in groove could cause damage to electrical wires and possible shock or fire hazard. ▲warning to avoid possible shock, do not pinch wires between the downrod/hanger ball assembly and the hanger bracket. 4. Carefully lift the fan and seat the downrod/hanger ball assembly...
8 installing the canopy housing figure 1a figure 1b note: this step is applicable after the necessary wiring is completed. 1. Loosen the two shoulder screws in the hanger bracket with a screwdriver (figure 1a). 2. Securely attach the canopy housing over the shoulder screws (figure 1b). 3. Securely a...
9 figure 1 replacing light bulbs 1. Turn off power. 2. Remove burned-out bulb(s). By gently pressing upward on the bulb, twisting counter-clockwise and pulling out the bulb. (figure 1). 3. Firmly seat the new bulbs in their sockets. By aligning pins with slots in socket, gently pressing upward and t...
10 before discarding packaging materials, be certain all parts have been removed parts list model #fp4820pw ref. # description part # 1 hanger bracket assembly with shoulder screws (2) apg610bl 2 downrod/hanger ball assembly containing: adr1-6pw 2a hanger ball assembly 2b downrod 2c hairpin clip 2d ...
Note: the illustration shown is not to scale or its actual confi guration or fi nish may vary the cumulos ™ fp4820pw exploded-view 4 7 1 figure 1 3 6 2a 9 10 11 8 5 2b 2c 2d 2 11.
10983 bennett parkway zionsville, in 46077 toll free (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 733-4113 visit our website www.Fanimation.Com copyright 2008 fanimation 2008/11.
