Fanimation FP4820PW The Cumulos Owner's Manual - page 4
4
Electrical and Structural Requirements
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit. The
outlet box must be securely anchored and capable of
withstanding a load of at least 50 lbs. Figure 1 depicts
different structural configurations that may be used for
mounting the outlet box.
Ceiling
Ceiling
Joists
2˝ x 4˝
Outlet
Box
Figure 1
▲WARNING
To avoid fire or shock, follow all wiring instructions
carefully. Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
▲WARNING
Turning off wall switch is not sufficent. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and the
ceiling fan must be properly grounded as a precaution
against possible electrical shock.
▲WARNING
To reduce the risk of fire, electrical shock, or personal
injury, mount fan to outlet box marked acceptable for
fan support. Use screws supplied with outlet box. Most
outlet boxes commonly used for support of light fixtures
are not acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
How to Assemble Your Ceiling Fan
Figure 1
Figure 2
Figure 3
1. Assemble Cable Support Arms (3) on top of fan motor
with screws (2 per arm) provided. (Figure 1)
2. Route the top of Cable Retainer through each hole on
underside of the acrylic disc. (Figures 2 & 3)
Screw (2 per
Support)
Cable Access
Hole (3 places)
Cable Retainer
Assembly (3)
Top of
Cable
Top of
Cable
(Ref)
Bottom
of Cable