Owner’s manual read and save these instructions model no’s. Fp4120 & fp6510 the keoki ™ /the mavrik ™ ceiling fan net weight of fan ass’y with uplight ass’y: 13.61 kg (30 lbs) the keoki™ fan fp4120** the mavrik™ fan fp6510**.
Table of contents unpacking instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 electrical and structural requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....
This manual is designed to make it as easy as possible for you to assemble, install, operate, and maintain your ceiling fan unpacking instructions for your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been completed and will be...
Clevis pin setscrew (2) 4 electrical and structural requirements ceiling ceiling joists 2˝ x 4˝ outlet box figure 1 how to assemble your ceiling fan pin setscrew hanger ball figure 1 1. Prior to assembly, set aside and save the hardware bag(s) packed in the packing. 2. Remove the hanger ball by loos...
5 how to assemble your ceiling fan (cont’d) 6. Route wires through opening in motor coupling cover. Position motor coupling cover on fan shown with open side facing down. (figure 2) 7. Route wires through opening in canopy. Position canopy on fan shown with open side facing up. (figure 3) 8. Reinsta...
6 how to hang your ceiling fan figure 3 figure 2 figure 1 outlet box hanger bracket outlet box hanger bracket screw (2) supplied with outlet box tab floor no less than 7 ft downrod/hanger ball assembly 1. Securely attach the hanger bracket to the outlet box using the outlet box screws and washers su...
7 how to wire your ceiling fan - c27 wall control how to operate your c27 wall control note: if fan or supply wires are different colors than indi- cated, have this unit installed by a qualified electrician. 1. Installing wall control (figures 1 & 2): • with electrical power still disconnected, remo...
8 installing the canopy housing 1. Screw in two threaded rods into the hanger bracket (figure 1a). Note: the threaded rods in the hanger bracket serve as guides for easier installation. 2. Securely attach the canopy housing to the hanger bracket using the external lockwashers and knurled knobs suppl...
9 figure 1 1. Place flat washer on the inside of lower housing cover (figure 1). Figure 2 note: to loosen finial nut; twist both lower housing cover and finial nut together counterclockwise. (figure 3) installing the lower housing cover maintenance blade cleaning periodic cleaning of your new ceilin...
10 before discarding packaging materials, be certain all parts have been removed parts list model # fp4120** & fp6510** ref. # description part # fp4120 part # fp6510 1 hanger bracket assembly apg510bl apg510bl 2 downrod/hanger ball assembly containing: adr6 ¾¾ adr6 ¾¾ 2a hanger ball assembly 2b dow...
11 note: the illustration shown is not to scale or its actual confi guration may vary fp4120** (as shown) / fp6510** exploded-view 4 1 figure 1 3 2a 11 ref 11 ref 6 5 10 8 2b 2c 2d 2 7 9 11.
12 trouble shooting ▲warning for your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan. Trouble probable cause suggested remedy 1. Fan will not start 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose switch wire connection...
10983 bennett parkway zionsville, in 46077 (888) 567-2055 fax (866) 482-5215 outside u.S. Call (317) 733-4113 visit our website www.Fanimation.Com copyright 2007 fanimation 2007/01.
