Fanimation Keoki FP4120 Series Owner's Manual - page 8
8
Installing the Canopy Housing
1. Screw in two threaded rods into the Hanger Bracket
(Figure 1a).
NOTE: The threaded rods in the hanger bracket serve as
guides for easier installation.
2. Securely attach the Canopy Housing to the Hanger
Bracket using the external lockwashers and knurled knobs
supplied with your fan (Figure 1b).
Figure 1a
Figure 1b
NOTE: Supply wires and fan wires omitted for clarity.
NOTE: This step is applicable after the neccessary wiring
is completed. (see page 7)
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
Assembling and Mounting the Fan Blades
1. Lay blade medallion with the threaded posts facing up.
2. Position the blade over the blade medallion with the
threaded posts showing through the holes of the blade. (See
insert for what side of blade that faces the medallion)
3. With a Philips screwdriver, tighten screws. Install blade
holder to blade medallion. (Figure 1)
4. Attach assembled blades and blade holders to the motor
hub using the provided screws and lockwashers.
(Figure 2)
5. Make sure the screws securing the blade holders to the
motor hub are tight and that the blade holders are properly
seated.
Figure 2
Fan Blade
Screw with
lockwasher
(2 per blade
holder)
Figure 1
Blade Holder
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
▲WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.
This (visible) side is the
blade medallion side