Fanimation Kubix FP4420 Series Owner's Manual - page 12
12
Operating Instructions - C24 Remote Control
1. Operating & Using Remote Transmitter (Figure 1):
Install 9 volt battery (If not using for long periods of time,
remove battery to prevent damage to transmitter). Store
the transmitter away from excess heat or humidity.
NOTE: If airflow is desired in the opposite direction, turn
the fan off and wait for the blades to stop turning. Then
slide the reverse switch to the opposite position and turn
fan on again. The reversing switch is located on top of the
fan motor assembly.
• HI Push Button – high fan speed
• MED Push Button – medium fan speed
• LOW Push Button – low fan speed
• OFF Push Button – fan off
• Light Push Button – on/off, hold for infinite light level
Figure 1
9V
Battery
▲WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades is in place. Noise and fan damage
could result.
Maintenance
Blade Cleaning
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth to
avoid scratching the fi nish.
Abrasive cleaning agents are not required and should be
avoided to prevent damage to fi nish.
Periodic light dusting of the blades is recommended. A
feather duster will work best.
Avoid using water, cleansers, or harsh rags, which can
warp and ruin the fi nish.
CAUTION
Do not use water when cleaning your ceiling fan. It could
damage the motor or the finish and create the possibility
of electrical shock.