Fanimation Punkah FP720 Series Specification Sheet - page 2
Weights (Approximate)
Fan Assembly Unit
5 lbs
Motor Assembly Unit
17½ lbs
**Available Finishes
AB
Antique Brass
PW Pewter
RS
Rust
Ordering Information
(Items Priced and Sold Separately)
Item
Catalog No.
Description
Fan Assembly Unit
FP720**
Use in ceiling or wall application
One push rod included (with each fan unit)
One Motor Unit
FP780**
120V, 60 Hz, ½ horsepower, 0.90 amp, 19 rpm,
single-speed; ON/OFF Switch (user supplied) only.
2 ft power cord (or can be hard-wired directly)
Maximum 6 Fan Assembly Units per Motor.
Blade Sets
(Order Separately)
See catalog for other blade options
NOTE:
18
˝
blades are recommended for most
installations
220V Model
(Export version)
Motor Assembly - 220 volt, 50 Hz
Ceiling / Wall Mount
Oscillating RPM: 19 (single-speed)
Available in 3 standard
fi
nishes
NOTES:
Installation is NOT recommended for sound
sensitive areas.
*
For spacing of 12
˝
to 27½
˝
cutting
push rods is required.
Not designed for signi
fi
cant air movement.
Not recommended for Damp Location.
C
B
A
D
E
F
Dimensions shown in inches
**
Insert Finish Codes
The Punkah
®
Ceiling Mount Assembly
Ceiling Assembly Speci
fi
cations
A
Overall Length
4´ to 24´
B
Support Spacing
12
˝
to 4´
C
Fan Base Unit
4½
˝
L x 4½
˝
W
D
Overall Drop
23
˝
with 18
˝
Blades
27
˝
with 22
˝
Blades
E
Blade Sweep
21
˝
with 18
˝
Blades
25½
˝
with 22
˝
Blades
F
Motor Assembly Unit
13¾
˝
L x 7¼
˝
W
C
F
NOTE:
Motor may also
be wall mounted
or mounted between
fan assemblies
INSTALLATION REQUIREMENTS
It is recommended that each fan and the motor have ¾
˝
plywood backing (12
˝
x12
˝
min.)
snug behind the sheet rock for adequate support. This may also be done with continuous
backing running the length of the fan system thus allowing the most
fl
exibility in placing
the blades.
ELECTRICAL REQUIREMENTS
A 120 VAC electrical feed is required and should be accessible to the
center of the motor. This circuit should be wired to an on/off switch
(Motor is single speed). The motor assembly is supplied with a 2 ft.
cord with plug. Motor assembly may be wired directly to electrical
outlet box. The Fan Blades oscillates at approximately 18-20 rpm.