Fanstasy Spas ELUSION Owner's Manual - Component Operation
14
COMPONENT OPERATION
SPA COMPONENT OPERATION
AIR CONTROL VALVE
The air control valve serves to regulate the amount of air mixed with the water when the jets
are operational. Rotate all the air control valves counterclockwise and observe the increased jet
action. Rotating the air control in the opposite direction to turn air off and allow the jets to work
with water only. Turn the air controls off when the spa is not in use, this will prevent cold air from
entering the spa and will keep heating cost to a minimum. The ozone jet, will always produce air
bubbles when pump is on.
WHIRLPOOL JET
(ELUSION MODEL ONLY)
The Whirlpool Jet is located below the water line at or near the control panel area, in the wall.
This jet is a diverter valve and high capacity jet that has a larger diameter than the hydrotherapy
jets. The whirlpool jet is turned on and off by rotating the jet face. Because, there is a substantial
amount of water pressure when the jet is in operation, you must turn the pump off or to low speed
before attempting to rotate the jet face. As the whirlpool jet open position is increased it will begin
turning off all of the hydrotherapy jets. One of the two air control valves is dedicated to the this jet.
HYDROTHERAPY JETS
The hydrotherapy jets are recessed in the wall of the spa. Rotate the medium jet faces counter-
clockwise to turn the jets on, clockwise to turn the jets off. Turning a jet on or off will increase or
decrease the effects of any jets not in the closed position.
MULTI-COLOR LED LIGHT
Your spa is installed with a multi-color LED light, pressing the light switch button on and off will
cause the light color to change to your desired color.
OZONE GENERATOR
(OPTIONAL)
The ozone system greatly enhances the quality of the spa water when used to supplement the spa
owner’s regular water maintenance program. Contrary to some information circulated throughout
the pool and spa industry regarding ozone systems, ozone
CAN'T be used as a single-source
sanitizer, water clarifier, anti-foamer, and mineral chelating agent. A secondary source sanitizer
must be used to maintain 3.0 - 5.0 ppm of Free Available Chlorine (FAC). Watkins Manufacturing
Corporation recommends that a chemical maintenance program based on recognized and
documented industry standards still be followed when using an ozone purification system to
assure water sanitation and the highest quality purified water.
WATERFALL
Your spa has a control valve to operate the amount of flow through the waterfall from no flow to
a steady stream. This valve is located next to the waterfall.
Note: The air control valve and the
waterfall flow valve may look and function exactly the same and may operate in the same way,
however; they will be separate components.