Fantasea LED 360 Light Operator's Manual - page 3
3
not to stare into the light beam which is very powerful and
could damage your eyes.
B. Gently remove the LED head (the white component with 36
LED bulbs) by pulling it out.
C. Install or remove the 4 AA Alkaline or Ni Cad batteries
carefully. Make sure that you follow the instructions
diagram printed on the inside of the light. Note that there
are two sets of two batteries, each set pointing in a
different direction.
D. Carefully replace the LED head, making sure that the red
line on the head corresponds with the red marking on the
inside of the battery compartment. This is the only way it
will fit properly.
E. Carefully place the plastic cover over the threads, and
tighten evenly in a clockwise fashion. Do not use force and
do not allow it to screw down unevenly. Take special care
not to stare into the light beam which is very powerful and
could damage your eyes.
F. It is recommended to occasionally apply a slight amount of
silicone grease to the black O-ring seal found on the
flashlight after unscrewing the flashlight head
counterclockwise.
G. The LED Light is now ready for use.
3. Assembling the LED 360 Light
A. When using the LED Light as a flashlight for night dives,
install the hand lanyard by tying it around the button loop
on the back side of the light. Use the hand lanyard in order
to secure the LED Light to your wrist.
B. When using the LED Light as a focus light integrated in an
underwater camera system, mount it on a Flex or Ball &