Fantasea LED 360 Light Operator's Manual - page 4
4
Joint arm by using the mounting ring and stainless steel
nut included with the light. Attach the arm to the tray on
which the housing is mounted on.
3. Turning the LED 360 Light On/Off
A. The LED 360 Light features 3 different positions, which are
indicated near the light’s switch:
• Off
• On
• Flasher
B. In order to switch the light on, slide the switch to the “ON”
position. The light is turned on and whenever a flash is
fired, the LED Light’s sensor shuts the light off for a
second, in order to prevent a hot spot in the image, caused
by the beam of the light. After a second, when the image
had been already captured, the light turns on again.
C. In order to switch the emergency flasher on, slide the
switch to the “FLASHER” position. The emergency flasher is
visible up to 5 km/3 miles at night, depending on weather
conditions.
D. In order to switch the light back off, slide the switch to the
“OFF” position.
E. After the dive, detach the LED 360 Light from the
underwater camera system. Soak and rinse exterior
components in fresh water.