Replacement parts household use only important safety instructions name of each part preparation before use using the vacuum cleaner using the attachments emptying the dust compartment cleaning the filters clearing blockages in the suction hose and cleaning the agitator assembly replacement instruct...
Important safety instructions when using an electrical appliance, basic precautions should always be followed, including the following. Read all instructions before using this vacuum cleaner warning - to reduce the risk of fire, electric shock or injury: 1. Do not leave the vacuum cleaner when plugg...
Note to user concerning attachment plug: 2 16. Do not touch the agitator while it is spinning. 17. Do not place any heavy items on top of the vacuum cleaner. 18. Do not step on the hose or pull it too strongly. 19. Do not pick up items such as pieces of waste paper or cloth which look as though they...
Set the on/off switch to " on " to light the headlight. 3 names of each part warning: operate vacuum cleaner only at the voltage specified on name plate. Front rear cleaning utensil headlight handle suction hose a dust compartment carrying handle duster knob on/off switch release button a release bu...
Caution: do not connect the power cord plug to the wall outlet until assembly is completed. Attaching the handle preparations before use attaching the suction hose a & attachments 4 1 2 set the vacuum cleaner to the upright position. Lnsert the handle as shown in the illustration. Handle wand crevic...
Releasing the power cord secure the power cord plug on the power cord. Warning: to reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse ...
On/off switch 6 using the vacuum cleaner on/off switch start or stop vacuum cleaner by pushing on the switch. Adjusting the handle upright position the handle is normally locked in this the handle of this vacuum cleaner can be set to one of three positions -upright, normal, parallel. Place your foot...
1 2 rug/floor (tools)selector the rug/floor(tools)selector should only be adjusted while the vacuum cleaner is turned on and in the upright position. When cleaning a rug or carpet,first turn the on/off switch to the on position,and then set the rug/ floor(tools)selector to the rug position. When cle...
Caution: when using one of the attachments during cleaning,set the vacuum cleaner to the upright position. 1 2 3 using the attachments press the release button c to disconnect the handle from the vacuum cleaner. Remove the attachments from the vacuum cleaner. Caution: when removing the attachments, ...
1 3 2 4 1 2 1 3 2 4 1 2 trapdoor projection groove release lever duster knob turn the duster knob several times in the direction shown to empty the dust compartment. Emptying the dust compartment caution: be sure to turn the on/off switch to the "off" position and disconnect the power cord from the ...
Remove the dust compartment.(refer to page 9) clean the filter fins free of dirt with the forked end of cleaning utensil as shown. Prefilter dust compartment ribs main filter 1 1 cleaning the filters 2 set the dust compartment to the parallel position.Open the trapdoor,then push the release button e...
Caution: be sure to turn the on/off switch to the "off" position and disconnect cleaning the agitator assembly 1 2 3 clearing blockages and cleaning the agitator assembly the power cord from the wall outlet before clearing any blockages in the suction hose and cleaning the agitator assembly. Cleanin...
Replacement instructions caution: be sure to turn the on/off switch to the"off" position and disconnect the power cord from the wall outlet before replacing any of the parts below. 1 set the vacuum cleaner to the parallel position. 2 loosen the screws to remove the lens. 3 when removing the headligh...
Place a new flat belt onto the motor shaft and pulley. 1 2 3 4 5 bearing holder groove nozzle head replacement instructions caution: be sure to turn the on/off switch to the"off" position and disconnect the power cord from the wall outlet before replacing any of the parts below. Replacing the flat b...
14 2 4 1 3 1 2 3 replacement instructions removing the bottom plate set the vacuum cleaner to the parallel position and turn it over. Slide the latch in the direction of the arrow. Remove the bottom plate by pulling the tabs as illustrated. Reattaching the bottom plate insert the projection on the b...
Caution: be sure that seal on the hepafilter is inserted towards the inside of the vacuum cleaner. The filter cover should be correctly oriented when it is reattached. Do not reattach it upside down. 3 insert a new hepafilter with the seal to the inside of the vacuum cleaner. Reattach the filter cov...
9bf-d-p111-00721 0304- if there is a problem with the vacuum cleaner, carry out the following checks to find the cause. If the problem still persists after the checks have been made, do not use the vacuum cleaner to prevent the possibility of an accident occurring. Turn the on/off switch to the "off...
Please fill out and mail the product registration card within ten (10) days of purchase. The registration will enable us to contact you in the unlikely event of a product safety notification. By returning this card you acknowledge to have read and understood the instructions for use, and warnings se...