Farfisa Compact User Manual - page 7
To assemble the Swell pedal (fig. D) loosen screws
( 19)
and slide outwards plate {20)
and fix it by tightening screws
( 19).
Connect recesses
( 21 )
to the studs of the bar across the
legs
( 1 1
fig. C) at the right of the player. Using the same procedure, the pedalboard is to be as
sembled at the left.
The Multi-tone-Booster lever
( 8
fig. B) must te taken out of the hook and put in vertical
position.
CONNECTION TO THE SWELL PEDAL AND PEDALBOARD
The plug ( 12 fig. C) is to te inserted into the input at the back of the base of swell pedal,
taking care the reference mark is downwards.
The connector of the pedalboard is to be inserted into the input under the instrument
(7
fig.
B). The wire of swell pedal is to be fixed to the grips
( 6a
fig. B), while the wire of the pedal
board is to
be fixed to the grips
(
6b
fig.
B}.
The other two wires, the one with a plug at one end and the other one for connection to the
mains, are to
be
fixed to the grips
( 6c fig.
B), taking care to fix 'the first the thinner wire.
CONNECTION TO THE FARFISA AMPLIFIERS MODELS
20
AND
40
Take care the knobs ( 16, 17, 18, 31, f
i
g
.
C) are completely turned clockwise.
Insert plug ( 13 fig
.
C) into the
«
ORGAN » input of the FARFISA amplifiers Close to the OR
GAN input there is a switch for« BASS » and« TREBLE », Switching on
«
BASS», you get standard
performance from Compact, whi·le switching on « TREBLE », you emphasize sharp incisive tunes,
particularly reqvired by modern music.
More power can be obtained Inserting plug into input No.2 of the 2nd channel of FARFISA «20Jt.
and
« 40
». In this case the
«
BASS
:t
and «MEDIUM» push buttons are to be inserted.
When using an amplifier other than FARFI SA MODEL
«20»
and
«40»,
see special instructions.
SEPARATE AMPLIFICATION OF TREBLE AND BASS
Wishing to have a separate amplification
of
Treble and Bass insert the plug of a second ampli
fier for Bass ( Farfisa model
BT
40 is recommended) into input 32 fig.
C.
CONNECTION TO CURRENT NETWORK
The cable for connection to the mains
( 14
fig
.
C) is supplied without plug and contains three
wires of different colours: RED and BLAK for the mains; BLUE or GREEN for connection to ground.
The connection to ground may be useful to avoid buzz deriving from the current network.
Compact works on A.C. 50/60Hz, 110/240 V.
Before connecting to the mains, be sure the voltag
e
switch
( 15
fig. C) shows the correct vol·
tage of the network.
Important:
It is dangerous to open the instrument when it is connected to the current net
work.
When
internal I
ns
pecti
o
n i needed, first disconnect
the
mains.
USE OF EARPHONE
The earphone outlet, placed near the ON/OFF switch, is meant for the use of an earphone
with impedance 2000
+
2000. In addition to silent practice, this is really useful for controlling a
performance, when lt is
directly
r
eco
r
ded into a tape recorder, without using the
amplifier.
5