Faroudja DVP 1080 Installation And Operation Manual - page 14
POWER / STANDBY
RESET
LCD DISPLAY
IR WINDOW
The DVP1080 offers easy control of picture adjust-
ments via an on-screen menu controlled by the 33
button remote control.
ON/OFF CONTROL
INPUT SELECTIONS
DIRECTIONAL CON-
TROL/MENU
PROFILE/STORE
NUMBER PAD
IMAGE ADJUSTMENT
14
DVP1080 OPERATION
INFRARED REMOTE CONTROL
FRONT PANEL CONTROLS
Each time the processor is powered up, it will go
through an initializing power-up sequence.
RESET: In the event of a processor firmware lockup,
insert a small paper clip into opening to reset. Stored
profiles and system settings will not be erased.
NOTE #1: Unplugging the unit from power source
will accomplish the same task.
POWER / STANDBY: Press to turn ON unit (LED
Green), press again to put unit in STANDBY (LED
Red).
NOTE #1: All settings are stored in nonvolatile
memory so a power loss will not result in loss of
settings.
IR WINDOW: Location of IR sensor for remote
control and IR remote systems
LCD READOUT: Provides information on the status
of the processor. The readout will match what is
being controlled via the OSD. It also provides readout
of the SETUP menu functions and unit warnings.
NOTE #1: The SETUP menu is only visible via the
front panel LCD.
ON-SCREEN DISPLAY (OSD)
There are four OSD menu pages: INPUT, PICTURE,
DISPLAY, PATTERNS.
INPUT: INPUT, ASPECT RATIO, PROFILES
PICTURE: BRIGHTNESS, CONTRAST, COLOR, TINT,
DETAIL, ADVANCED COLOR CONTROL
DISPLAY: IMAGE POSITION, IMAGE BLANKING
PATTERNS: TEST PATTERN ON/OFF, SELECT
The remote control is used to access these menus.