Faroudja DVP5000 Installation And Operation Manual - page 12
To activate the control of the DVP5000 press:
To turn On press:
To select an Input press:
Each press toggles to the next input or press
the number pad while the OSD is visible for:
1. Composite Video
2. S-Video
3. Component
4. D1 (Reserved)
5. HDTV
6. HDTV/Computer Pass-through
To select a User Preset press:
Repeated pressing will toggle through the four
User and one Factory presets.
The presets can also be directly accessed by
pressing the PRESET button and then the keypad:
0 = Factory
1 = User Preset 1
2 = User Preset 2
3 = User Preset 3
4 = User Preset 4
The User Presets store all picture adjustment
information including scan rate, output format
and Aspect Ratio. To Store the settings press:
The OSD will display which preset is currently
selected. Select the desired preset to store the
information using the Value keys and then press
the Store key again.
To change Aspect Ratio press:
Repeat pressing will toggle through the differ-
ent Aspect Ratios (If available. See the Setup
section for details). Pressing the Value key after
pressing the Aspect key will also toggle through
the choices.
The Aspect Ratios can also be directly
accessed by pressing the ASPECT button and
then the keypad:
1 = 4:3
2 = Letterbox
3 = Anamorphic
Brightness can be accessed by pressing:
Then adjust the Values by pressing the
buttons. For direct access, press the BRIGHT
button, then enter the value on the keypad
such as 138.
Contrast can be accessed by pressing:
Then adjust the Values by pressing the
buttons. For direct access, press the
CONTRAST button, then enter the value on the
keypad such as 158.
Color can be accessed by pressing:
11
OPERATION
FDJA
POWER
INPUT
CENTER
PRESET
SUR
ASPECT
MENU
BRIGHT
LAST
CONTRAST
PIP
COLOR
SWAP
STORE
ENTER