Fastora Fastora NAS T2 Hardware Installation Manual - page 18
FASTORA NAST2 Server Hardware Installation Guide
3.2 Appliance Indicators and Connectors
The FASTORA NAST2 server has the following indicators of control and connectors.
1
2
3
4
5
3.2.1 Power control and reset buttons
4
Power control
button
1. When the A/C power cable is in socket, the appliance will start to initiate.
2.
Press this button once to shutdown the appliance, and then press once again to switch on the appliance.
Attention:
1.
When the appliance is switched on, press this button continuously over 4 seconds to switch off the power
directly. This switch-off activity should happen only when the appliance is hung; otherwise it may make the
appliance non-operational or damage the drives.
2.
It takes around 20 seconds for shutdown.
3.2.2 Indicators of Ethernet control
2
Link/Active LED of LAN port # 1
1.
This green LED is on when Ethernet port #1 in linking 100Mb speed connection. It flashes when there is
transmit or receive activity to or from the appliance.
2.
This Yellow LED is on when Ethernet port #1 in linking 10Mb speed connection. It flashes when there is
transmit or receive activity to or from the appliance.
3
Link/Active LED of LAN port # 2 for Gigabit Lan
1. This green LED is on when Ethernet port #1 in linking 1000Mb speed connection. It flashes when there is
transmit or receive activity to or from the appliance.
2.
This Yellow LED is on when Ethernet port #1 in linking 100Mb speed connection. It flashes when there is
transmit or receive activity to or from the appliance.
Starting the Appliance
12