Fastora Fastora NAS T2 Hardware Installation Manual - Safety Precautions
Safety Precautions
Before getting started, read the following important cautions.
1.
Be sure to ground yourself to prevent static charge when installing the internal components.
Use a grounding wrist strap and place all electronic components in any static-shielded devices.
Most electronic components are sensitive to static electrical charge.
2.
Disconnect the power cords from the FASTORA NAS before making any installation. Be sure
both the system and the external devices are turned OFF. Sudden surge of power could ruin
sensitive components. Make sure the FASTORA NAS is properly grounded.
3.
Do not open the system’s top cover. If opening the cover for maintenance is a must, only a
trained technician is allowed to do so. Integrated circuits on computer boards are sensitive to
static electricity. To avoid damaging chips from electrostatic discharge, observe the following
precautions:
Before handling a board or integrated circuit, touch an unpainted portion of the system unit
chassis for a few seconds. This will help to discharge any static electricity on your body.
When handling boards and components, wear a wrist-grounding strap, available from most
electronic component stores.
Trademarks Acknowledgments
AXIOMTEK is a trademark of AXIOMTEK Co., Ltd.
Other brand names and trademarks are the properties of their respective owners.
iv