Fastpac FP-AM7215-1X3 Configuration Manual

2015  Adaptive Technologies Group,   Signal Hill, CA   90755(562) 424-1100 

R2-08270-115

Figure 1 

FASPAC

TM

FP-AM7215-3X1 

3 WIDE X1 DEEP PLANAR ARRAY CONFIGURATION 

The FP-AM7215-3X1 planar array kit  give designers, contractors and audio 

consultants the ability to create a three wide AM7215, or AM5215 speakers in a tight 

pack planar array configurations.  The FasPac 

TM

 provides a method of flying a tight 

pack array while offering the capability of allowing cabinets to be adjusted relative to 

each other to find the optimum sound directivity. A series of holes are provided to 

easily adjust the splay angle from 0° to 30° at an increment of 2.5 degree. 

Installing speakers must be performed by experienced professionals. If in 

doubt about the integrity of the structure you are mounting or suspending to or not 

sure about the proper hardware or method to use, consult a certified rigging 

company. 

Package contents: 

4 pcs 

7-2645 Front Joiner Plate 

2 pcs 

7-2647 Rear Joiner Plate 

14 pcs   

Button head socket screw, M10x1.5-45MM long    

15 pcs   

M10 flat washers   

2 pcs 

M10 x 50mm long eyebolt 

2 pcs 

M10 x 35 mm long eyebolt

CAUTION: PLEASE READ CAREFULLY BEFORE PROCEEDING

Due to the wide variety of building structures, materials and suspension methods, 

these instructions assume that the installing contractor/installer will exercise good 

judgment in selecting the proper mounting area and hardware. As a guide, the 

installation, when complete, should be capable of supporting at least 5 

times the actual load.  

Follow building code requirements to safely suspend the speakers to the 

building structure 

Step 1:  

Flip speakers so that the bottom is facing up. Unscrew existing speaker 

screws and discard. 

Step 2: 

Determine the splay angle of the speaker and the holes to use on the front 

joiner plate (Figure 2).  

Step 3:  

Install the rear joiner plate on the rear rigging inserts to secure the side 

speakers to the center using the slots of the plates. Use the provided M10 

screws and washers (Figure 1).  Install two front joiner plates on the two 

front rigging inserts of the speakers using the corresponding holes for the 

appropriate splay angles using the, screws, and washers (Figure 1). Make 

sure the markings on the plates are facing up. Do not tighten screws; 

leave it snug until all plates are in position. 

Step 4:  

Slowly flip the speaker assembly so that the tops of the speakers are 

facing up. Unscrew the speaker screw and discard (Figure 1).