Fastpac FP-AM7215-1X3 Configuration Manual - page 4
2015 Adaptive Technologies Group, Signal Hill, CA 90755(562) 424-1100
R2-08270-115
Figure 4 (With TCK2 Adj. Tilt cable Kit, sold separately)
Figure 2
Step 5:
When all plates are in position, tighten all screws permanently.
Step 6:
Lay the speaker cluster on its side the install eyebolts to the side rigging
points (now top) of the speaker as shown (Figure 3A). Install eyebolts on the
rear rigging points of the lower speaker. Use either double pull back points
(Figure 3A) or single point pull back (Figure 3B).
Step 7:
Use the eyebolts on the top of the speaker cluster as the main speaker
suspension points. Use the lower eyebolts of the lower speaker for pull back
points and to adjust the tilt angle of the speaker cluster assembly (main
illustration and Figure 4).
Step 8:
Check all hardware connections before hoisting cluster.
Figure 3A (Four point suspension)
Figure 3B (three point suspension)