FaVal MERCURY S100 Operating Instructions Manual - page 20
Eliminating malfunctions
_______________________________________________________________
20
Eliminating malfunctions
Symptom
Possible cause and remedy
The power cable is not connected.
Connect the power cable to the power socket.
The display does not work.
The power switch is not switched on.
Switch on the power switch.
No tone, picture, LED on
the receiver.
The receiver is in standby.
Press the "POWER" button. The receiver switches on
and the program will be shown on the TV screen.
The antenna is not adjusted to the satellite.
Adjust the antenna properly.
No tone or picture.
No signal or weak signal.
Check the cable connection from the LNB to the
receiver and from the receiver to the connected
devices.
Adjust the antenna.
The system is not properly connected.
Check the SCART or HF cable connection.
The TV set has no picture.
The TV set is not in AV mode.
Switch the TV set to the respective AV input.
The antenna is not adjusted to the satellite.
Adjust the antenna.
Bad picture, error
The LNB is defective.
Replace the LNB.
The batteries are drained.
Replace the batteries with new ones.
The remote control does
not function.
The remote control is incorrectly aimed.
Aim the remote control to the front of the
receiver and make sure that nothing is between
the remote control and receiver.
If the malfunction is not eliminated, please contact your specialized dealer.