1. DL manuals
  2. FAVI
  3. Projector Accessories
  4. RioHD-LED-2
  5. Instructions Manual

FAVI RioHD-LED-2 Instructions Manual

Other manuals for RioHD-LED-2: User Manual, User Manual

Summary of RioHD-LED-2

  • Page 1

    Favi universal mount instructions, led-2 projector. Before you begin, please make sure you have the following tools on hand: ● socket driver with an 8mm socket ● 7mm wrench and socket an allen wrench is also required. Your mount comes supplied with this already. Step 1: loosen the four 8mm bolts loc...

  • Page 2

    Step 3: on the removed leg, use the allen wrench to remove the inner leg. In your mount’s accessory bag, you should find a shorter inner leg. Replace the longer inner leg with the shorter inner leg. Tighten the bolt just enough to allow the piece to slide freely inside the outer leg. Step 4: on the ...

  • Page 3

    If need be you can use a small pair of needle nose pliers to remove these foot pads. Step 5: attach the leg assembly to the projector. Use the 7mm bolts to attach the mount’s legs to the projector. For now, only attach the bolts loosely..

  • Page 4

    Step 6: use the last 7mm bolt to loosely attach the final leg to the projector. You can then rotate the leg and slide it into the leg assembly. Replace the 8mm bolt you removed in step 2. Do not tighten it yet. Step 7: after adjusting the leg assembly so that the middle is lined up with the front of...

  • Page 5

    Step 9: reinsert the two screws that you removed in the previous step and tighten them. After the projector is mounted, you can loosen these two screws to change the angle of the projector. Step 10: locate the height adjuster. It consists of two rectangular tubes, one inside the other. It should loo...

  • Page 6

    The projector mount can now be attached to the ceiling. After securing the mount to the ceiling, you can adjust the height and angle of the projector..