Introduc tion ------------------------------------------------------------------------------ safety instructions ---------------------------------------------------------------------- getting started --------------------------------------------------------------------------- connecting a pc to your ...
1 16 ● no warm up time: plug in the projector, turn it on, and it begins projecting almost immediately. ● small size: at just over 8 inches wide and weighing under 3 pounds, the riohd-led-2 is designed with portability in mind. ● low power consumption: uses only 60 watts of electricity. ● long lamp ...
15 2 do not operate this projector in an environment where the temperature is above 104 ºf. Doing so could damage your projector and void your warranty. Do not expose this projector, or its power supply to liquids. If the projector’s casing becomes dirty, use a damp soft cloth or paper towel to clea...
14 1 2 3 5 • 3 the following diagrams point out the features of your projector: 4 6 7 8 9 10 11 1: power button 2: indicator led 3: front ventilation slots 4: lens 5: a/v and power input panel. 6: ir sensor 7: rear ventilation slots 8: vga input 9: keystone adjustment wheel 10: front height adjustme...
13 4 a/v s-v ideo y /pb /pr v ga hdm i selecting a video mode your projector is set to a/v mode by default. To use your projector in another video mode, you must set it to that mode. If for example you want to use your projector in vga mode, you will need to set it to that mode. To change video mode...
12 5 here is a picture of your projector’s a/v and power input panel. The connectors are all labeled, and are self explainatory. If you want the best possible image clarity, use the component (y/pb/pr) jacks, or the hdmi port. If you want to make use of the 16:9 downsampling, or you have a device th...
11 6 the remote control that comes with your projector is also used for other models, some of which have different sets of features. The image below points out which buttons activate features on your projector. 1 2 3 4 5 6 7 1: mute button. 2: power button. 3: image preset select button. 4: menu, an...
7 10 if your pc’s video card has a dvi or hdmi port, you can also use an hdmi cable to connect your pc to your projector’s hdmi port. For pc video cards that only have a dvi port, a dvi to hdmi adapter (not included) is also required. Your projector supports a 60 hertz refresh rate. Higher refresh r...
8 9 front projection table mount rear projection table mount screen screen projector projector the projector is angled too far to the right. The projector is angled too far to the left the projector is s et up correctly. The following diagram shows two examples of how your projector can be set up. F...
