Fbt symbol 12000 User Manual - page 3
2
PRECAUTIONS
UNPACKING
WARNING
!
||
|
<
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER (OR BACK)
NO USER SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK
DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE
- Read this manual thoroughly and observe the following precautions before working with the amplifier.
- Take care not to spill liquids onto the amplifier and do not use it in excessively humid conditions.
- Do not install the amplifier near heat sources or expose it to direct sunlight and do not install in dusty environments without suitable
protection.
- Do not obstruct the air intake openings or the cooling fans.
- Ensure the power supply voltage does not exceed the value shown on the rear panel.
- Do not use the amplifier unless the mains cable and plug are in perfect condition (replace or repair if necessary).
- To safeguard against induced interference, do not install the amplifier next to transformers, television sets, RF transmitters, motors or
electrical power sources of any description.
- Do not use solvents such as acetone or alcohol to clean the amplifier or the finish and panel lettering will be damaged.
- Do not connect output channels to input channels of other appliances and do not connect the CH1 OUT/CH2 OUT power outputs to any
load other than the relative input connector on the loudspeakers.
- Do not connect audio inputs to electrical power sources of any type.
- If a fault occurs, consult your nearest FBT service centre or a specialized audio equipment repair service. Do not attempt to repair the
amplifier yourself.
Although all FBT products are carefully inspected and tested before shipment, they could be damaged in transit. When removing the packing material inspect
the amplifier carefully for any sign of damage. Inform your dealer immediately if the amplifier is damaged on arrival.
Keep the packing material on hand so that it can be re-used if the amplifier must be shipped to a service centre at any time or in the event of resale. Note that
this type of equipment holds its market value well, provided it is kept in good condition and can be supplied in its original packing together with the handbook.