FDS FD141CV-C-1 Installation And Operation Manual - page 10
Document Number:
MAN
– FD141CV-C-1
Rev:
B
Revision Date:
05/04/2017
Page 10 of 15
©
2017 FDS Avionics Corp.
All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
Button Controls
Located on the front-right side of the FD141CV-C-1 are 8 buttons. These buttons are used to
power up the unit and navigate through the different menus. The menu button is used as a
toggle, push to view the menu screens, push again to exit.
BUTTON DESCRIPTION
PWR
Turns ON/OFF the system.
MENU
Activates the OSD menu or
goes to previous menu.
AUTO
Auto-adjustment in RGB.
Moves the highlight icon up to
the function that user wants.
Moves the highlight icon down
to the function that user
wants.
Decreases the adjustment of
the selected function.
Increases the adjustment of
the selected function.
SCE*
Selects the Input Signal
among
VGA/DVI/Composite/SDI.
*NOTE
– To utilize the quad SDI image or any of the quad SDI inputs (I, 2, 3, 4). The
Source must first be selected as “SDI” on the right hand side buttons. Use the
SCE button to cycle to the SDI input.