Fearless Night Digital LED Clock Operating Instructions - page 4
Digital LED Clock
FearlessNight.com
Page
4
IR Remote Control
Requirements
You will need an IR remote control that works with Panasonic devices (TV, VCR, etc). Most
universal remotes (for example, the URC-3220 "One-For-All") will work. Some functions, such as
Mute, can only be activated via IR remote control.
Setup
Decide on which type of device you want to use to control the clock. This should be a device that
you are not already using. For example, if you have a Panasonic TV but no Panasonic VCR, then
use the VCR device to control the clock. We will use the VCR device an example in the following
instructions.
To set up your IR remote control, refer to the IR remote control user guide to program it for an
appropriate device. For example, using the URC-3220 "One-For-All" remote control you could set
up any one of these devices to control the clock:
Device
URC-3220 program code
TV 0250
VCR 1062
SAT 0701
To configure the clock to respond to your IR remote control, first unplug the clock. Then while
pressing the clock control button, plug in the clock. The clock display should show “ir” and a number
from 1 to 4. The devices that you can choose are:
Device
Number shown on Clock “ir” display
TV 1
VCR 2
CBL, SAT, etc.
3
AUX 4
Now set the IR remote control for the desired device (e.g. press the VCR button on the IR remote
control) and then press the IR remote control “power” button while pointing the IR remote control at
the front of the clock. When the clock detects the signal, it will start displaying the date and time
normally.
Use
Now you can use the IR remote control, when set for the VCR device, to control the clock functions
as follows (see Time Run / Time Set instructions for the Control Switch functions):
IR Remote button
Clock Control Function
rec/prog
Same as pressing the Control Switch
ch-up
Same as Up on the Control Switch
ch-dn
Same as Down on the Control Switch
vol-up
Same as Left on the Control Switch
vol-dn
Same as Right on the Control Switch
mute
Blank/restore display [must hold down for 5 secs]
0-9
Sets constant brightness from dim (0) to bright (9)
Note
The “mute” IR signal is the same for all Panasonic devices! In order to allow independent control of
the clock and your other devices, the clock will only respond if the IR remote control Mute button is
held for at least 5 seconds.