Feedback TR-1000 Installation And Maintenance Manual - page 16
16
EXAMPLE SET
-
UP SCREEN...
This is a representation of the network card setup
screen. However, it may not look exactly the same depending on type.
*** basic parameters
Hardware: Ethernet TPI
IP addr
-
0.0.0.0/DHCP/BOOTP/AutoIP, no gateway set
DHCP device name : not set
*** Security
SNMP is enabled
SNMP Community Name: public
Telnet Setup is enabled
TFTP Download is enabled
Port 77FEh is enabled
Web Server is enabled
Web Setup is enabled
ECHO is disabled
Encryption is disabled
Enhanced Password is disabled
Port 77F0h is enabled
*** Channel 1
Baudrate 9600, I/F Mode 4C, Flow 00
Port 09100
Connect Mode : C0
Send '+++' in Modem Mode disabled
Auto increment source port disabled
Remote IP Adr:
---
none
---
, Port 00000
Disconn Mode : 00 Disconn Time: 05:00
Flush Mode : F7
Pack Cntrl : 20
SendChars : FE 00
*** Expert
TCP Keepalive : disabled
ARP cache timeout: 600s
Monitor Mode @ bootup : enabled
HTTP Port Number : 80
MTU Size: 1400
Alternate MAC: disabled
Ethernet connection type: auto
-
negotiate
Change Setup:
0 Server
1 Channel 1
2 Channel 2
3 E
-
5 Expert
6 Security
7 Defaults
8 Exit without save
9 Save and exit Your choice ?
NOTES
: To change the configu-
ration of the network card, use the
relevant option under ‘
Change
Setup:
’.
Option
0
:
Server
is where the IP
address, subnet mask and gate-
way are set. By default they are
set to DHCP via an IP address of
0.0.0.0.
Option
1
:
Channel 1
is where the
parameters required for the TR
-
1000 terminal to communicate
correctly are set. In normal cir-
cumstances these will have been
factory set by Feedback.
Option
5
:
Expert
needs to have
TCP Keep Alive
disabled e.g.
set to
0
seconds.
Option
7
:
Defaults
, does
NOT
refer to the settings that have pre-
viously been set at Feedback prior
to despatch. It refers to the default
settings when the card is new.
COMMISSIONING THE TERMINAL