Fei Bao F18-f Assembly Manual - page 15
14
F E I B A O F 1 8 - f
You can hold the servo with wooden blocks by cutting 3 for each side then drill holes through
them then screw them to the servo, then put a little epoxy on the side that goes to the inner wing.
And clamp it there over night to dry or you can purchase servo wing holders from your dealer
that glue on the inside of the wing and then there is 3 screws that hold the servo in place as seen
in the pictures.
Cut a slot in the cover for the servo horn approx. 1” long which should do for the movement of
the servo then drill a hole at each end like the lower picture shows and draw a line on each side
as shown then use a new sharp exacto blade to cut the lines. After satisfied with the slot screw
the cover back in place.
Attach the provided linkage to the servo horn
Prepare all 6-control horns. Roughen up the bottom portion on both sides by using 40 grit
sandpaper or a dremel to give you a better gluing bond.