Fein 60250 Instruction Manual - Chip Removal

10 

SIGHTING NOTCH FOR FREE-HAND CUTTING 

Sighting notches (A) near the front of the baseplate provides guidance. When performing 

free-hand cutting (at 90 degrees) the cutting line for the saw blade can be observed through a 

u-shaped sighted notch at the front of the base plate.   

Align the cutting line on the workpiece with the v- 

shaped sighting notch at the front of the base plate   

when cutting at 45 degree angle. (This is due to the   

placement of the pivot point). 

Turn saw on before contacting workpiece, wait until   

the blade reaches full RPM before proceeding with cut.    Apply 

Apply even pressure all of the way through cut to   

ensure proper blade operation and to obtain smoother 

cutting. 

Beware:

 Beware of the kickback at the instant the running blade touches the workpiece. 

CHIP REMOVAL 

GLASS WINDOW

The chips can be observed through a glass window. When the chip shield area is half full, remove 

the cover by loosening the two bolts and empty the contents. Make sure the chips have been 

removed completely. 

Way to clean the cutting chips 

1.  Unscrew the knob bolts (A) on the blade housing. 

Refer to Fig.22

2.  Remove chip shield (B). (keeping the bolts 

screwed on guard). Refer to Fig.23 

3.  Remove the chips. 

Beware: Always keep the saw away from your body   

when removing the chip shield, the chips will fall out.   

The chips could be very hot, be careful not to touch them 

when you remove the chip shield. 

Fig.21

A 

Fig.22

A 

Fig.23