Fein 60250 Instruction Manual - Direction of Sawing

9 

DIRECTION OF SAWING 

Align saw blade to the right of the operator. 

OVERLOAD PROTECTION 

Under extreme overload, the current consumption   

may considerably exceed the permissible nominal   

value. In this case, overload protection prevents   

the motor from burning out. The saw has a reset 

button (A) that will restart the motor after it shuts   

off due to extreme overload, if the motor stops during operation, turn the ON/OFF switch to the   

OFF position. Unplug the saw from its power source. Wait about three minutes for the motor   

to cool down. Push in on the reset button and turn the switch to the on position. Refer to Fig.19 

THE GUIDE RULER 

The guide ruler can be used to cut a straight sawing 

line along the workpiece and can be affixed at the   

front of base with the wing nut. The guide ruler (C)   

can be used on the right side of the blade only,   

shown in Fig.20. Using the guide provides accurate 

cuts compared to free-

 hand cutting. Locate the guide   

into the mounting slots (A) at the front of the baseplate   

and tighten the wing screw (B) to lock it at the desired   

cut width. Refer to Fig.20 

C 

A 

B 

Fig.20 

Fig.19 

A