Fein BLK1.3CS Original Instructions Manual - page 19
19
en
Original instructions Nibbler.
Symbols, abbreviations and terms used.
Symbol, character
Explanation
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Before commencing this working step, pull the mains plug out of the socket. Otherwise there
will be danger of injury if the power tool should start unintentionally.
Use eye-protection during operation.
Use ear protection during operation.
Use protective gloves during operation.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
Confirms the conformity of the power tool with the directives of the European Community.
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environment-friendly recycling.
Product with double or reinforced insulation
Ø
Diameter of a round part
Max. work piece thickness for steel with up to 400 N/mm
2
Max. work-piece thickness for steel with up to 600 N/mm
2
Max. work-piece thickness for steel with up to 800 N/mm
2
Max. work piece thickness for aluminium with up 250 N/mm
2
Pilot-drill for inside cut-outs
Min. inside curve radius
Weight according to EPTA-Procedure 01/2003
Character
Unit of measure,
international
Unit of measure,
national
Explanation
n
0
/min
spm
Stroke rate at no-load
n
S
m/min
m/min
Cutting speed
P
1
W
W
Power input
P
2
W
W
Output
M…
mm
mm
Size of metric thread
L
wA
dB
dB
Sound power level
L
pA
dB
dB
Sound pressure level
K…
Uncertainty
m/s
2
m/s
2
Acceleration
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
/min, m/s
2
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
rpm, m/s
2
Basic and derived units of measure from the inter-
national system of units
SI
.
WARNING
Fe 400
Fe 600
Fe 800
Al 250
Ø
r
3 41 01 100 06 0.book Seite 19 Freitag, 5. Dezember 2008 11:55 11